Evido EAD-D2000 Instrukcja Obsługi Pobierz pdf (Strona 75)

Note

This UART setting page is based on 1 channel encoder for H.264. If your camera or

encoder model is other than this model, move to the chapter ‘6.REFERENCE TO

MODEL’ to check the differences between models.

For the USRT setting, go to Setup > IO Configuration > UART. The UART setting page (UART1 or

UART2) may not be supported depending on the device type.

The UART setup is supported with two different pages; UART1 and UART2. For the RS485 port,

use the UART1 setup page. For the RS232C port, use the UART2 setup page.

Internal

PTZ: Used when you connect a PTZ camera to an encoder. RS485 is for UART1 and RS232 is for

UART2.

AUX: Used when you connect an auxiliary device that requires serial communication to an

encoder. RS485 is for UART1 and RS232 is for UART2.

SerialOverIP: Used to enable the communication for the devices connected to the serial ports

of an encoder

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 95 96

Brak uwag

Evido EAD-D2000 Instrukcja Obsługi Strona 75