Evido EAD-D2000 Instrukcja Obsługi Pobierz pdf (Strona 73)

To set up DI/DO and UART, go to Setup > IO Configuration. This menu is configured with two

sub menus: DI/DO and UART.

Note

This DI/DO setting page is based on EAD-E1000 Analytics Encoder. If your camera or

encoder model is other than this mode, move to the chapter ‘6.REFERENCE TO

MODEL’ to check the difference between models.

If you should install the additional device such as alarm system or sensor system, you can

configure the DI (Digital Input) and DO (Digital Out) in this page.

You can choose the DI resource type, RELAY or VOLTAGE (The maximum is 5V).

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 95 96

Brak uwag

Evido EAD-D2000 Instrukcja Obsługi Strona 73